During a weekend failover rehearsal, engineers discover that users cannot use a backup SD-WAN link because the security policy does not match the shared SD-WAN zone. What specific failure risk follows if the underlying fault remains?
Failover can still be blocked by a policy tied to an obsolete physical uplink. SD-WAN zone policy matching must permit the selected member path after routing decisions. The described exposure follows from leaving the SD-WAN zone-based policy dependency unresolved.
It would be a concern if SD-WAN route eligibility and gateway were misconfigured. Here SD-WAN zone policy matching must permit the selected member path after routing decisions. The selected alternative does not follow from the observed fault.
That risk is associated with SD-WAN lowest-cost strategy rather than the failing SD-WAN zone-based policy dependency. Lowest cost (SLA) selects the least-cost link that meets configured quality targets. The present scenario establishes a different causal exposure.
It would be a concern if performance SLA active probes were misconfigured. Here SD-WAN zone policy matching must permit the selected member path after routing decisions. The selected alternative does not follow from the observed fault.
A post-incident review at a cloud operations team identifies that a new WAN member was added but the LAN-to-Internet policy still references only the former physical interface. The same control is still uncorrected. Which exposure should the risk register record?
Failover can still be blocked by a policy tied to an obsolete physical uplink. SD-WAN zone policy matching must permit the selected member path after routing decisions. The described exposure follows from leaving the SD-WAN zone-based policy dependency unresolved.
This describes a separate application-aware steering failure. Ordered SD-WAN service rules can steer selected applications based on classification and link conditions. It does not identify the most direct consequence of leaving SD-WAN zone-based policy unresolved.
That risk is associated with SD-WAN route eligibility and gateway rather than the failing SD-WAN zone-based policy dependency. SD-WAN selection still relies on a valid route and firewall policy for the traffic. The present scenario establishes a different causal exposure.
This describes a separate SD-WAN implicit rule failure. SD-WAN explicit service rules are evaluated before applicable implicit/default forwarding behavior. It does not identify the most direct consequence of leaving SD-WAN zone-based policy unresolved.
At a factory network running FortiOS 7.6, both WAN interfaces show physical link up even though one ISP drops application packets intermittently. Which configuration or investigative change most directly resolves this issue?
Configure suitable SD-WAN performance SLA health checks with real probe targets and thresholds. Performance SLAs measure path quality rather than merely physical interface status. This corrects the FortiGate behavior described by the specific performance SLA active probes fault.
This correction targets SD-WAN implicit rule. SD-WAN explicit service rules are evaluated before applicable implicit/default forwarding behavior. It does not repair the stated performance SLA active probes condition: both WAN interfaces show physical link up even though one ISP drops application packets intermittently.
Changing this could help when the fault is SD-WAN link recovery, because sD-WAN health status drives eligible route use and must measure a meaningful reachable target. Here the evidence instead identifies performance SLA active probes; the recommended correction addresses that dependency.
The proposed setting concerns SD-WAN lowest-cost strategy, not the actual source of failure. Performance SLAs measure path quality rather than merely physical interface status. It would leave the cited symptom unresolved.
During an incident-response triage, administrators want SD-WAN to detect loss and jitter that link-state checks cannot reveal. What should the FortiGate administrator change to meet the stated requirement?
Configure suitable SD-WAN performance SLA health checks with real probe targets and thresholds. Performance SLAs measure path quality rather than merely physical interface status. This corrects the FortiGate behavior described by the specific performance SLA active probes fault.
The proposed setting concerns SD-WAN DSCP-specific prioritization, not the actual source of failure. Performance SLAs measure path quality rather than merely physical interface status. It would leave the cited symptom unresolved.
This correction targets SD-WAN link recovery. SD-WAN health status drives eligible route use and must measure a meaningful reachable target. It does not repair the stated performance SLA active probes condition: administrators want SD-WAN to detect loss and jitter that link-state checks cannot reveal.
Changing this could help when the fault is manual SD-WAN rule preference, because manual SD-WAN rules let administrators specify eligible outgoing interface preference. Here the evidence instead identifies performance SLA active probes; the recommended correction addresses that dependency.
An e-commerce platform discovers a FortiGate control gap during a weekend failover rehearsal: both WAN interfaces show physical link up even though one ISP drops application packets intermittently; additionally, administrators want SD-WAN to detect loss and jitter that link-state checks cannot reveal. Which targeted correction should the team implement?
Configure suitable SD-WAN performance SLA health checks with real probe targets and thresholds. Performance SLAs measure path quality rather than merely physical interface status. This corrects the FortiGate behavior described by the specific performance SLA active probes fault.
The proposed setting concerns SD-WAN route eligibility and gateway, not the actual source of failure. Performance SLAs measure path quality rather than merely physical interface status. It would leave the cited symptom unresolved.
Changing this could help when the fault is SD-WAN implicit rule, because sD-WAN explicit service rules are evaluated before applicable implicit/default forwarding behavior. Here the evidence instead identifies performance SLA active probes; the recommended correction addresses that dependency.
The proposed setting concerns best quality SD-WAN, not the actual source of failure. Performance SLAs measure path quality rather than merely physical interface status. It would leave the cited symptom unresolved.
The international service desk team is verifying its fix for an incident where both WAN interfaces show physical link up even though one ISP drops application packets intermittently. Which specific observation most convincingly demonstrates the required FortiGate behavior?
Measurements report latency, jitter and packet loss per member, correctly marking the degraded path. Performance SLAs measure path quality rather than merely physical interface status. This is directly observable evidence for the performance SLA active probes requirement, rather than a generic appliance-health indicator.
That observation is a useful test for application-aware steering, but not decisive proof of performance SLA active probes. Ordered SD-WAN service rules can steer selected applications based on classification and link conditions. The recorded acceptance check must demonstrate the actual requirement.
This verifies a different control: SD-WAN implicit rule. Performance SLAs measure path quality rather than merely physical interface status. The stated incident requires evidence of its own packet, identity or policy behavior.
That observation is a useful test for SD-WAN lowest-cost strategy, but not decisive proof of performance SLA active probes. Lowest cost (SLA) selects the least-cost link that meets configured quality targets. The recorded acceptance check must demonstrate the actual requirement.
After a segmentation review, administrators correct a problem where administrators want SD-WAN to detect loss and jitter that link-state checks cannot reveal. Which test result should their acceptance record contain?
Measurements report latency, jitter and packet loss per member, correctly marking the degraded path. Performance SLAs measure path quality rather than merely physical interface status. This is directly observable evidence for the performance SLA active probes requirement, rather than a generic appliance-health indicator.
This verifies a different control: SD-WAN link recovery. Performance SLAs measure path quality rather than merely physical interface status. The stated incident requires evidence of its own packet, identity or policy behavior.
A result about SD-WAN implicit rule can be true while the performance SLA active probes defect persists. SD-WAN explicit service rules are evaluated before applicable implicit/default forwarding behavior. It does not validate the tested dependency.
That observation is a useful test for manual SD-WAN rule preference, but not decisive proof of performance SLA active probes. Manual SD-WAN rules let administrators specify eligible outgoing interface preference. The recorded acceptance check must demonstrate the actual requirement.
An auditor reviewing a financial services branch deployment finds that both WAN interfaces show physical link up even though one ISP drops application packets intermittently. The team claims this is resolved; which concrete evidence would substantiate that claim?
Measurements report latency, jitter and packet loss per member, correctly marking the degraded path. Performance SLAs measure path quality rather than merely physical interface status. This is directly observable evidence for the performance SLA active probes requirement, rather than a generic appliance-health indicator.
That observation is a useful test for best quality SD-WAN, but not decisive proof of performance SLA active probes. SD-WAN best-quality strategy compares measured link metrics when choosing eligible members. The recorded acceptance check must demonstrate the actual requirement.
This verifies a different control: SD-WAN implicit rule. Performance SLAs measure path quality rather than merely physical interface status. The stated incident requires evidence of its own packet, identity or policy behavior.
A result about SD-WAN link recovery can be true while the performance SLA active probes defect persists. SD-WAN health status drives eligible route use and must measure a meaningful reachable target. It does not validate the tested dependency.
If a multi-site university leaves the following FortiGate issue unresolved—both WAN interfaces show physical link up even though one ISP drops application packets intermittently—what is the most direct operational or security consequence?
SD-WAN can keep sending applications through an unusable Internet path when only carrier state is checked. Performance SLAs measure path quality rather than merely physical interface status. The described exposure follows from leaving the performance SLA active probes dependency unresolved.
That risk is associated with SD-WAN route eligibility and gateway rather than the failing performance SLA active probes dependency. SD-WAN selection still relies on a valid route and firewall policy for the traffic. The present scenario establishes a different causal exposure.
This describes a separate SD-WAN lowest-cost strategy failure. Lowest cost (SLA) selects the least-cost link that meets configured quality targets. It does not identify the most direct consequence of leaving performance SLA active probes unresolved.
That risk is associated with SD-WAN implicit rule rather than the failing performance SLA active probes dependency. SD-WAN explicit service rules are evaluated before applicable implicit/default forwarding behavior. The present scenario establishes a different causal exposure.
During a quarterly security audit, engineers discover that administrators want SD-WAN to detect loss and jitter that link-state checks cannot reveal. What specific failure risk follows if the underlying fault remains?
SD-WAN can keep sending applications through an unusable Internet path when only carrier state is checked. Performance SLAs measure path quality rather than merely physical interface status. The described exposure follows from leaving the performance SLA active probes dependency unresolved.
It would be a concern if SD-WAN zone-based policy were misconfigured. Here Performance SLAs measure path quality rather than merely physical interface status. The selected alternative does not follow from the observed fault.
This describes a separate manual SD-WAN rule preference failure. Manual SD-WAN rules let administrators specify eligible outgoing interface preference. It does not identify the most direct consequence of leaving performance SLA active probes unresolved.
It would be a concern if application-aware steering were misconfigured. Here Performance SLAs measure path quality rather than merely physical interface status. The selected alternative does not follow from the observed fault.
A post-incident review at a supply-chain company identifies that both WAN interfaces show physical link up even though one ISP drops application packets intermittently. The same control is still uncorrected. Which exposure should the risk register record?
SD-WAN can keep sending applications through an unusable Internet path when only carrier state is checked. Performance SLAs measure path quality rather than merely physical interface status. The described exposure follows from leaving the performance SLA active probes dependency unresolved.
This describes a separate SD-WAN implicit rule failure. SD-WAN explicit service rules are evaluated before applicable implicit/default forwarding behavior. It does not identify the most direct consequence of leaving performance SLA active probes unresolved.
That risk is associated with manual SD-WAN rule preference rather than the failing performance SLA active probes dependency. Manual SD-WAN rules let administrators specify eligible outgoing interface preference. The present scenario establishes a different causal exposure.
It would be a concern if SD-WAN link recovery were misconfigured. Here Performance SLAs measure path quality rather than merely physical interface status. The selected alternative does not follow from the observed fault.
Please check your mailbox for a message from support@examlabs.com and follow the directions.
