You save $69.98
300-415 Premium Bundle
- Premium File 480 Questions & Answers
- Last Update: Nov 11, 2026
- Training Course 112 Lectures
- Study Guide 874 Pages
You save $69.98
A fabric administrator recommends the following change: Check the Edge control-connection history and attempt reachability to the configured Validator endpoint. The triggering scenario is: A branch can ping its transport default gateway but control connections show no established peers. Which underlying SD-WAN behavior BEST explains the response?
Control sessions require successful underlay reachability and Validator-assisted discovery before overlay exchange. This technical mechanism explains why the recommended action works: Check the Edge control-connection history and attempt reachability to the configured Validator endpoint. A successful deployment should show: The diagnostics identify whether discovery, transport routing, or secure handshake is failing.
Controller control-connection longevity depends on stable transport, NAT and authenticated secure session state. This principle is associated more closely with another situation: A site loses Controller peers every few minutes even though its WAN circuit stays physically up.
Control components must independently establish authenticated connections over their transport network. This principle is associated more closely with another situation: A new Controller can reach the Manager but cannot build the expected secure session to its Validator.
PKI enrollment signs a controller public key to establish a verifiable identity for mutual authentication. This principle is associated more closely with another situation: An SD-WAN Manager generates a CSR for a new Controller but the administrator assumes it is already trusted.
Consider this Catalyst SD-WAN operating scenario: A legacy branch uses EIGRP toward the LAN and the new Catalyst Edge must maintain learned network reachability. Which corrective response most directly meets the requirement?
Apply a supported EIGRP service-VPN feature with intentional route redistribution and platform checks. This is the targeted action for the stated case: A legacy branch uses EIGRP toward the LAN and the new Catalyst Edge must maintain learned network reachability. The specific technical reason is: EIGRP may provide service-side routing information on supported WAN Edges for controlled OMP exchange. Verification should demonstrate: EIGRP neighbors and authorized remote overlay routes appear in their intended routing tables.
Make the neighbor-address field device-specific in the appropriate Manager feature template or profile. This would help with a different network situation: One device template is shared by 200 sites, but only the BGP neighbor address should differ per Edge.
Configure BGP neighbors in the appropriate service VPN and controlled BGP/OMP route redistribution. This would help with a different network situation: A data-center Edge peers with existing BGP routers and must maintain route policies while joining the fabric.
Update the device inventory and approved provisioning mapping for the replacement Edge. This would help with a different network situation: A replacement WAN Edge is installed at a branch but the old router's serial remains authorized and the new serial is missing.
A Catalyst SD-WAN operations review encounters this case: A headquarters network is learned through BGP but is advertised to remote SD-WAN sites under the wrong VPN ID. What failure mode is MOST directly associated with leaving it uncorrected?
Incorrect VPN labeling can leak a service prefix or make it disappear from its intended tenant. OMP advertises service routes in a specific VPN context rather than in a universal unsegmented routing table. The recommended mitigation is: Verify the BGP-to-OMP redistribution context and VPN membership of the learned prefix.
Using two unrelated gateway IPs without coordinated failover can disrupt local client traffic. That risk applies mainly to a different case: Two branch Edges face the same user VLAN and need a single virtual default gateway that survives device failure.
Resetting WAN Edge hardware does not address a Controller filtering OMP prefixes. That risk applies mainly to a different case: A Controller has route advertisements but an Edge's OMP route table shows no routes for a particular customer VPN.
Equating transport TLOC reachability with service route advertisement can lead to false troubleshooting conclusions. That risk applies mainly to a different case: A technician sees a reachable TLOC on the Controller but no corresponding business LAN prefix.
A Cisco Catalyst SD-WAN deployment engineer is handling this requirement: An enterprise requires alternate remote paths without accidentally preferring a withdrawn TLOC after an outage. Which action BEST addresses the situation?
Inspect OMP route and TLOC state along with data tunnel BFD liveliness before evaluating next-hop policy. This is the targeted action for the stated case: An enterprise requires alternate remote paths without accidentally preferring a withdrawn TLOC after an outage. The specific technical reason is: A usable OMP service route depends on current resolved transport locators and healthy tunnel state. Verification should demonstrate: The withdrawn TLOC is removed from usable forwarding candidates and reachable paths remain.
Review the OMP advertised-path limit and confirm intended equal-cost path distribution. This would help with a different network situation: One Edge has an OMP neighbor session that is up, yet route propagation stops after the configured path limit.
Check both OMP TLOC and OMP vRoute advertisement categories from the originating WAN Edge. This would help with a different network situation: A technician sees a reachable TLOC on the Controller but no corresponding business LAN prefix.
Make the neighbor-address field device-specific in the appropriate Manager feature template or profile. This would help with a different network situation: One device template is shared by 200 sites, but only the BGP neighbor address should differ per Edge.
An engineer proposes this Catalyst SD-WAN remedy: Evaluate Cloud OnRamp for Colocation and its supported service-chain architecture. The triggering scenario is: A branch needs a centralized security and service-chain location at a partner colocation facility before reaching external services. Which underlying SD-WAN behavior BEST explains the response?
Cloud OnRamp for Colocation integrates SD-WAN connectivity with shared colocation service functions. This technical mechanism explains why the recommended action works: Evaluate Cloud OnRamp for Colocation and its supported service-chain architecture. A successful deployment should show: Traffic from the branch traverses the authorized colocation service devices before the intended destination.
Cloud OnRamp for Multicloud coordinates supported cloud networking and interconnect connectivity patterns. This principle is associated more closely with another situation: An enterprise must interconnect two cloud providers and several SD-WAN sites through a managed global backbone.
Cloud OnRamp for IaaS requires both overlay connectivity and appropriate cloud-side route propagation. This principle is associated more closely with another situation: A company uses Cloud OnRamp for IaaS but branch prefixes are missing from the hosted application's routing domain.
A TLOC identifies a WAN Edge transport endpoint using system IP, color, and encapsulation rather than an IP alone. This principle is associated more closely with another situation: A route is advertised with a transport locator, and an operator assumes the TLOC is merely the public interface IP address.
A fabric administrator recommends the following change: Use the appropriate Multi-Region Fabric inter-region border controls and route policy design. The triggering scenario is: The enterprise spans three regional fabrics, and an administrator wants to suppress needless routes outside their home region. Which underlying SD-WAN behavior BEST explains the response?
Hierarchical SD-WAN regions manage route distribution across distinct regional forwarding domains. This technical mechanism explains why the recommended action works: Use the appropriate Multi-Region Fabric inter-region border controls and route policy design. A successful deployment should show: Regional-only destinations remain local while explicitly permitted destinations cross the correct border nodes.
Cloud OnRamp for Colocation integrates SD-WAN connectivity with shared colocation service functions. This principle is associated more closely with another situation: A branch needs a centralized security and service-chain location at a partner colocation facility before reaching external services.
A TLOC identifies a WAN Edge transport endpoint using system IP, color, and encapsulation rather than an IP alone. This principle is associated more closely with another situation: A route is advertised with a transport locator, and an operator assumes the TLOC is merely the public interface IP address.
IPsec protects WAN Edge overlay data-plane packets while the underlay merely transports the encrypted traffic. This principle is associated more closely with another situation: A branch uses broadband underlay and the owner requires confidential payload forwarding between WAN Edge routers.
A Cisco Catalyst SD-WAN deployment engineer is handling this requirement: A regional firewall is being replaced and service-chain traffic must fail to a supported alternate instance. Which action BEST addresses the situation?
Plan redundancy and supported service insertion failover behavior for the service chain. This is the targeted action for the stated case: A regional firewall is being replaced and service-chain traffic must fail to a supported alternate instance. The specific technical reason is: Service insertion can select redundant service functions when the service topology and policy support it. Verification should demonstrate: During a controlled firewall outage, protected flows traverse the approved secondary inspection path.
Configure service insertion with the appropriate centralized data policy and reachable firewall service path. This would help with a different network situation: Payment traffic entering the SD-WAN fabric must traverse an approved firewall before reaching a protected data-center application.
Verify service advertisement, VPN matching and data policy service-chain action for the regional node. This would help with a different network situation: A branch relies on a regional security appliance but the policy uses a service destination that is not advertised in the correct VPN.
Verify supported DNS redirection or forwarding configuration and policy application at the Edge. This would help with a different network situation: A DNS security integration is provisioned but requests continue to use a local resolver that bypasses the approved service.
An engineer proposes this Catalyst SD-WAN remedy: Configure the application class and SLA-aware path preference for broadband with eligible MPLS fallback. The triggering scenario is: A video conference should use broadband normally but MPLS when broadband exceeds a latency threshold. Which underlying SD-WAN behavior BEST explains the response?
AAR associates application traffic with measured transport SLA and ordered path preferences. This technical mechanism explains why the recommended action works: Configure the application class and SLA-aware path preference for broadband with eligible MPLS fallback. A successful deployment should show: Simulated broadband delay causes only matched conference traffic to shift to MPLS.
Overlay topology is shaped by centralized control-plane route distribution and site membership. This principle is associated more closely with another situation: A hub-spoke topology is requested without relying on every site manually building static routes.
AAR relies on measured performance characteristics beyond basic data tunnel liveliness. This principle is associated more closely with another situation: An engineer uses BFD up/down alone to claim that a video application receives sufficient QoE.
SLA measurement windows and policy preferences influence when an application changes overlay paths. This principle is associated more closely with another situation: AAR path changes oscillate as transport loss fluctuates around a threshold during busy hours.
A Cisco SD-WAN deployment has completed the following step: Use a supported data policy service-insertion action and appropriate service reachability. The original case is: A security team wants branch traffic for one application redirected through a central inspection service. Which test result provides the strongest evidence that the change succeeded?
A controlled application session traverses the inspected service before arriving at the target network. This observable result validates the corrective action: Use a supported data policy service-insertion action and appropriate service reachability.
Voice packets in the target tenant receive the configured treatment; other tenant VPN traffic is unchanged. That observation would verify another change: A regional policy must affect only voice traffic from one service VPN, without touching data traffic in another tenant VPN. The expected result instead is: A controlled application session traverses the inspected service before arriving at the target network.
Service VPN clients reach public destinations through approved VPN 0 internet egress. That observation would verify another change: A service VPN needs direct internet access, but the route to the ISP is visible only inside VPN 0. The expected result instead is: A controlled application session traverses the inspected service before arriving at the target network.
Traffic captures show inventory on MPLS and permitted guest web flows on the intended broadband exit. That observation would verify another change: A branch's guest web traffic must use broadband while inventory transactions must use MPLS, regardless of shared destination prefixes. The expected result instead is: A controlled application session traverses the inspected service before arriving at the target network.
After a controlled WAN fabric change, operations reports this action: Use the SD-WAN Controller for OMP route distribution and reserve the Validator for orchestration and discovery. The original case is: A new branch can contact the public SD-WAN Validator, but the engineer mistakenly expects that component to distribute all branch routes. Which specific measurement would justify closing the change ticket?
Control connections form through the Validator and OMP route advertisements appear at the SD-WAN Controller. This observable result validates the corrective action: Use the SD-WAN Controller for OMP route distribution and reserve the Validator for orchestration and discovery.
Monitoring identifies the specific TLOC pair with elevated jitter during affected voice calls. That observation would verify another change: An MPLS tunnel and internet tunnel are up, yet VoIP MOS drops during bursts of jitter on one path. The expected result instead is: Control connections form through the Validator and OMP route advertisements appear at the SD-WAN Controller.
Cloud route tables and Edge overlay routes show bidirectional reachability for authorized branch prefixes. That observation would verify another change: A company uses Cloud OnRamp for IaaS but branch prefixes are missing from the hosted application's routing domain. The expected result instead is: Control connections form through the Validator and OMP route advertisements appear at the SD-WAN Controller.
BFD reports the actual data tunnel health and the unavailable path is no longer preferred for traffic. That observation would verify another change: A site has working Controller connections, but an application tunnel stops passing packets when the circuit degrades. The expected result instead is: Control connections form through the Validator and OMP route advertisements appear at the SD-WAN Controller.
An engineer proposes this Catalyst SD-WAN remedy: Match DIA by the correct service VPN and traffic class instead of adding a universal internet breakout. The triggering scenario is: A guest VPN may use DIA but corporate finance traffic must continue through the inspected headquarters gateway. Which underlying SD-WAN behavior BEST explains the response?
SD-WAN policy scopes direct internet breakout by service VPN and permitted traffic categories. This technical mechanism explains why the recommended action works: Match DIA by the correct service VPN and traffic class instead of adding a universal internet breakout. A successful deployment should show: Guest traffic exits locally while finance sessions follow the mandated central inspection route.
DIA changes the traffic security enforcement point and requires planned local or cloud protection. This principle is associated more closely with another situation: A branch enables direct internet breakout for employees without a firewall or DNS security plan.
Data policies can selectively steer or redirect matched flows through service-chain paths. This principle is associated more closely with another situation: A security team wants branch traffic for one application redirected through a central inspection service.
DIA bridges authorized service-side internet traffic to the transport underlay under explicit routing policy. This principle is associated more closely with another situation: A service VPN needs direct internet access, but the route to the ISP is visible only inside VPN 0.
or Guarantee your success by buying the full version which covers the full latest pool of questions. (480 Questions, Last Updated on Nov 11, 2026)
Please check your mailbox for a message from support@examlabs.com and follow the directions.