JN0-364 Premium File
- 69 Questions & Answers
- Last Update: Nov 4, 2026
During provider troubleshooting at Crestpoint Research, this symptom is observed: Two eBGP routes have equal earlier BGP decision attributes and the operator needs to explain why a path with fewer AS numbers is preferred. Which targeted inspection should precede remediation?
This check may help with another root cause, for example: A neighbor's agreed selective-routing behavior fails because a community is added after the rejecting export term rather than before policy selection. It does not test the first failed condition; start with: Inspect all candidate BGP path attributes in selection order, especially local preference and AS-path list, rather than only ping latency.
Inspect all candidate BGP path attributes in selection order, especially local preference and AS-path list, rather than only ping latency. AS-path manipulation may influence selection, but cannot be assumed to override higher local preference.
The check diagnoses a different layer of service. Its source issue is: A provider changed a partner's ASN, leaving the old `peer-as` on its Junos BGP group while TCP connection attempts continue. The relevant initial check is: Inspect all candidate BGP path attributes in selection order, especially local preference and AS-path list, rather than only ping latency.
This check may help with another root cause, for example: A provider receives a malformed or unauthorized customer prefix yet it enters route selection after a loose import policy. It does not test the first failed condition; start with: Inspect all candidate BGP path attributes in selection order, especially local preference and AS-path list, rather than only ping latency.
A production change request at Eastvale MetroNet includes this finding: A provider advertises two links to a neighboring AS and wishes to express a preferred ingress while keeping the links as separate BGP paths. What should the engineer change to address it?
Use an appropriate externally communicated MED or an agreed inbound routing policy and verify the neighbor's comparison behavior and limitations. The case-specific reason is: BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path. A direct acceptance test is: The neighboring AS receives the intended MED values where applicable and its selected ingress matches the mutually understood path policy.
This action may apply to a different problem, for example: A provider changed a partner's ASN, leaving the old `peer-as` on its Junos BGP group while TCP connection attempts continue. It does not repair the stated failure boundary. The case-specific reason is: BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path.
This action may apply to a different problem, for example: A received iBGP route is visible in inet.0 but inactive because its BGP next hop cannot be resolved through the IGP. It does not repair the stated failure boundary. The case-specific reason is: BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path.
The other action is relevant when A planned customer route appears in the partner's advertisements but Junos rejects it at an early inbound policy term. The current case instead requires: Use an appropriate externally communicated MED or an agreed inbound routing policy and verify the neighbor's comparison behavior and limitations. The distinction is: BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path.
After Eastvale MetroNet applies its proposed fix to this problem — A provider advertises two links to a neighboring AS and wishes to express a preferred ingress while keeping the links as separate BGP paths. — which observation best proves the specific failure has been resolved?
That check proves something else, such as: A provider changed a partner's ASN, leaving the old `peer-as` on its Junos BGP group while TCP connection attempts continue. It could pass while the stated problem remains. The targeted evidence here is: The neighboring AS receives the intended MED values where applicable and its selected ingress matches the mutually understood path policy.
That check proves something else, such as: A backbone operator needs to prefer a primary egress for all internal routers without changing the external partner's AS path length. It could pass while the stated problem remains. The targeted evidence here is: The neighboring AS receives the intended MED values where applicable and its selected ingress matches the mutually understood path policy.
This would be valid for another situation: A transit customer prefix is locally active but never advertised to an approved eBGP neighbor because the export policy's final term rejects it. It does not establish that the failing boundary in this scenario works; verify: The neighboring AS receives the intended MED values where applicable and its selected ingress matches the mutually understood path policy.
The neighboring AS receives the intended MED values where applicable and its selected ingress matches the mutually understood path policy. BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path.
An architecture review at Eastvale MetroNet examines the following symptom: A provider advertises two links to a neighboring AS and wishes to express a preferred ingress while keeping the links as separate BGP paths. What Junos or protocol mechanism is most directly responsible?
The statement can be true when A provider changed a partner's ASN, leaving the old `peer-as` on its Junos BGP group while TCP connection attempts continue. But it does not explain the reported failure. Here: BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path.
The statement can be true when An edge advertises unapproved internal prefixes after an operator broadens a BGP export term beyond the intended customer route set. But it does not explain the reported failure. Here: BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path.
That principle belongs to a different service stage: A provider receives a malformed or unauthorized customer prefix yet it enters route selection after a loose import policy. The directly relevant mechanism is: MED suggests a preferred entry point to a neighboring AS under its own BGP selection rules; local preference is internal to an AS.
MED suggests a preferred entry point to a neighboring AS under its own BGP selection rules; local preference is internal to an AS. The key distinction is: BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path. Accordingly the remedy is: Use an appropriate externally communicated MED or an agreed inbound routing policy and verify the neighbor's comparison behavior and limitations.
The team at Eastvale MetroNet defers a fix for this condition: A provider advertises two links to a neighboring AS and wishes to express a preferred ingress while keeping the links as separate BGP paths. What failure is most likely if no targeted control is applied?
It is a risk in another topology or protocol state: A provider receives a malformed or unauthorized customer prefix yet it enters route selection after a loose import policy. Here the most direct failure path is: An attempted ingress optimization can fail silently because the remote router does not compare or honor the attribute as expected.
The concern could occur elsewhere when A service route remains hidden after an eBGP-to-iBGP handoff; the internal router knows the prefix but not a path to its advertised next hop. For the stated scenario, the immediate risk is: An attempted ingress optimization can fail silently because the remote router does not compare or honor the attribute as expected.
An attempted ingress optimization can fail silently because the remote router does not compare or honor the attribute as expected. The direct mitigation is: Use an appropriate externally communicated MED or an agreed inbound routing policy and verify the neighbor's comparison behavior and limitations.
It is a risk in another topology or protocol state: A backbone operator needs to prefer a primary egress for all internal routers without changing the external partner's AS path length. Here the most direct failure path is: An attempted ingress optimization can fail silently because the remote router does not compare or honor the attribute as expected.
During provider troubleshooting at Eastvale MetroNet, this symptom is observed: A provider advertises two links to a neighboring AS and wishes to express a preferred ingress while keeping the links as separate BGP paths. Which targeted inspection should precede remediation?
The check diagnoses a different layer of service. Its source issue is: Two neighboring providers configured for eBGP have IP reachability but the BGP session remains Active because one side uses the wrong peer AS number. The relevant initial check is: Check outbound advertised path attributes and the remote neighbor's policy and MED comparison rules rather than assuming remote local preference.
Check outbound advertised path attributes and the remote neighbor's policy and MED comparison rules rather than assuming remote local preference. BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path.
That evidence could be normal while the reported defect persists. It is aimed at: Two paths learned inside one AS reach the same destination; the selected exit conflicts with policy despite the chosen link having fewer AS hops. Instead inspect: Check outbound advertised path attributes and the remote neighbor's policy and MED comparison rules rather than assuming remote local preference.
The check diagnoses a different layer of service. Its source issue is: Two eBGP routes have equal earlier BGP decision attributes and the operator needs to explain why a path with fewer AS numbers is preferred. The relevant initial check is: Check outbound advertised path attributes and the remote neighbor's policy and MED comparison rules rather than assuming remote local preference.
At Bridgeway Cloud, a service provider router shows this failure: An operator changes local preference on its own router expecting a remote AS to honor it, but the remote side never receives that attribute. What is the best targeted configuration or operations action?
This action may apply to a different problem, for example: An edge advertises unapproved internal prefixes after an operator broadens a BGP export term beyond the intended customer route set. It does not repair the stated failure boundary. The case-specific reason is: BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path.
The other action is relevant when A provider receives a malformed or unauthorized customer prefix yet it enters route selection after a loose import policy. The current case instead requires: Use an appropriate externally communicated MED or an agreed inbound routing policy and verify the neighbor's comparison behavior and limitations. The distinction is: BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path.
That would address a separate configuration fault: Two eBGP routes have equal earlier BGP decision attributes and the operator needs to explain why a path with fewer AS numbers is preferred. This stem identifies a different cause, corrected by: Use an appropriate externally communicated MED or an agreed inbound routing policy and verify the neighbor's comparison behavior and limitations.
Use an appropriate externally communicated MED or an agreed inbound routing policy and verify the neighbor's comparison behavior and limitations. The case-specific reason is: BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path. A direct acceptance test is: The neighboring AS receives the intended MED values where applicable and its selected ingress matches the mutually understood path policy.
A change auditor at Bridgeway Cloud must validate remediation of this finding: An operator changes local preference on its own router expecting a remote AS to honor it, but the remote side never receives that attribute. Which test outcome is the strongest acceptance evidence?
This would be valid for another situation: An edge advertises unapproved internal prefixes after an operator broadens a BGP export term beyond the intended customer route set. It does not establish that the failing boundary in this scenario works; verify: The neighboring AS receives the intended MED values where applicable and its selected ingress matches the mutually understood path policy.
The observation confirms a different component's behavior. Its source context is: A provider receives a malformed or unauthorized customer prefix yet it enters route selection after a loose import policy. In this case the success criterion is: The neighboring AS receives the intended MED values where applicable and its selected ingress matches the mutually understood path policy.
That check proves something else, such as: A neighbor's agreed selective-routing behavior fails because a community is added after the rejecting export term rather than before policy selection. It could pass while the stated problem remains. The targeted evidence here is: The neighboring AS receives the intended MED values where applicable and its selected ingress matches the mutually understood path policy.
The neighboring AS receives the intended MED values where applicable and its selected ingress matches the mutually understood path policy. BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path.
The operations training team at Bridgeway Cloud discusses this issue: An operator changes local preference on its own router expecting a remote AS to honor it, but the remote side never receives that attribute. Which technical explanation matches the intended correction?
MED suggests a preferred entry point to a neighboring AS under its own BGP selection rules; local preference is internal to an AS. The key distinction is: BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path. Accordingly the remedy is: Use an appropriate externally communicated MED or an agreed inbound routing policy and verify the neighbor's comparison behavior and limitations.
This explains a separate protocol behavior: A provider receives a malformed or unauthorized customer prefix yet it enters route selection after a loose import policy. In the current facts, the controlling mechanism is: MED suggests a preferred entry point to a neighboring AS under its own BGP selection rules; local preference is internal to an AS.
The statement can be true when Two eBGP routes have equal earlier BGP decision attributes and the operator needs to explain why a path with fewer AS numbers is preferred. But it does not explain the reported failure. Here: BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path.
That principle belongs to a different service stage: A received iBGP route is visible in inet.0 but inactive because its BGP next hop cannot be resolved through the IGP. The directly relevant mechanism is: MED suggests a preferred entry point to a neighboring AS under its own BGP selection rules; local preference is internal to an AS.
At Bridgeway Cloud, a service acceptance review considers the unresolved issue: An operator changes local preference on its own router expecting a remote AS to honor it, but the remote side never receives that attribute. Which operational exposure follows most directly?
That consequence is more closely associated with another deficiency, such as: Two eBGP routes have equal earlier BGP decision attributes and the operator needs to explain why a path with fewer AS numbers is preferred. The described fault instead exposes: An attempted ingress optimization can fail silently because the remote router does not compare or honor the attribute as expected.
It is a risk in another topology or protocol state: A team assumes periodic UPDATE messages keep a quiet BGP session alive, but the route table is stable and no updates are due. Here the most direct failure path is: An attempted ingress optimization can fail silently because the remote router does not compare or honor the attribute as expected.
An attempted ingress optimization can fail silently because the remote router does not compare or honor the attribute as expected. The direct mitigation is: Use an appropriate externally communicated MED or an agreed inbound routing policy and verify the neighbor's comparison behavior and limitations.
That consequence is more closely associated with another deficiency, such as: A BGP speaker learns a route from one iBGP peer but does not pass it to another internal peer, causing partial prefix visibility. The described fault instead exposes: An attempted ingress optimization can fail silently because the remote router does not compare or honor the attribute as expected.
Before changing configuration at Bridgeway Cloud, an engineer investigates: An operator changes local preference on its own router expecting a remote AS to honor it, but the remote side never receives that attribute. Which first diagnostic most directly tests the suspected cause?
That evidence could be normal while the reported defect persists. It is aimed at: A backbone operator needs to prefer a primary egress for all internal routers without changing the external partner's AS path length. Instead inspect: Check outbound advertised path attributes and the remote neighbor's policy and MED comparison rules rather than assuming remote local preference.
The check diagnoses a different layer of service. Its source issue is: A received iBGP route is visible in inet.0 but inactive because its BGP next hop cannot be resolved through the IGP. The relevant initial check is: Check outbound advertised path attributes and the remote neighbor's policy and MED comparison rules rather than assuming remote local preference.
This check may help with another root cause, for example: A planned customer route appears in the partner's advertisements but Junos rejects it at an early inbound policy term. It does not test the first failed condition; start with: Check outbound advertised path attributes and the remote neighbor's policy and MED comparison rules rather than assuming remote local preference.
Check outbound advertised path attributes and the remote neighbor's policy and MED comparison rules rather than assuming remote local preference. BGP MED is a hint under neighbor policy, not a guaranteed cross-AS command to select one path.
Please check your mailbox for a message from support@examlabs.com and follow the directions.