You save $69.98
300-415 Premium Bundle
- Premium File 480 Questions & Answers
- Last Update: Nov 11, 2026
- Training Course 112 Lectures
- Study Guide 874 Pages
You save $69.98
An engineer proposes this Catalyst SD-WAN remedy: Separate controller placement and supported cluster redundancy across independent host failure domains. The triggering scenario is: An on-premises controller cluster loses quorum after two virtual nodes share one physical failure domain. Which underlying SD-WAN behavior BEST explains the response?
Controller resiliency depends on redundant instances and sound underlying hosting failure-domain design. This technical mechanism explains why the recommended action works: Separate controller placement and supported cluster redundancy across independent host failure domains. A successful deployment should show: A planned host loss leaves the required controller services functioning at supported scale.
Redundant orchestration components improve onboarding resilience when deployed and advertised correctly. This principle is associated more closely with another situation: The enterprise deploys only one SD-WAN Validator in a critical global fabric and worries about provisioning outages.
Control-channel establishment and OMP routing exchange are distinct troubleshooting stages. This principle is associated more closely with another situation: An Edge reports established control connections but no remote service prefixes appear in its OMP table.
The management-plane platform requires independent capacity planning from WAN Edge dataplane throughput. This principle is associated more closely with another situation: An on-premises Manager is underprovisioned and cannot retain telemetry for hundreds of routers.
A network troubleshooting report describes the following condition: A control node's identity certificate will expire during a planned campus change freeze. Which consequence explains why this issue must be addressed?
Allowing controller certificates to expire can disconnect otherwise healthy Edge routers. Secure control sessions require current signed device certificates that remain within their validity interval. The recommended mitigation is: Inspect certificate expiration and renew it through an approved enrollment process before the deadline.
Deploying undersized controller VMs can cause unstable control sessions and management performance. That risk applies mainly to a different case: A company must operate its own SD-WAN Controllers in a private virtualization cluster.
Certificate trust with inconsistent organization identity can still prevent fabric participation. That risk applies mainly to a different case: Two controller nodes use different organization-name values despite sharing the same trust root.
A CSR is only a signing request and cannot replace the signed identity certificate. That risk applies mainly to a different case: An SD-WAN Manager generates a CSR for a new Controller but the administrator assumes it is already trusted.
Consider this Catalyst SD-WAN operating scenario: A new branch can reach a hub's external service VPN but not a second shared-services VPN. Which corrective response most directly meets the requirement?
Verify that the branch is an authorized member of the second VPN and that its routes are exported. This is the targeted action for the stated case: A new branch can reach a hub's external service VPN but not a second shared-services VPN. The specific technical reason is: VPN membership and route distribution determine which segment's prefixes each Edge can access. Verification should demonstrate: The correct second VPN's routes appear after membership and control-policy corrections.
Keep customer LAN routing in dedicated service VPNs and reserve VPN 0 for underlay transport. This would help with a different network situation: A transport network engineer proposes placing all customer VRF interfaces into VPN 0 because it is already globally reachable.
Design a hub-and-spoke overlay route topology with selected site lists and allowed VPN routes. This would help with a different network situation: A company wants branches to reach headquarters servers but forbids direct branch-to-branch sessions.
Define the appropriate backup default exit, NAT, and transport failover for the permitted traffic. This would help with a different network situation: Two broadband circuits provide DIA but the primary ISP becomes unavailable during an office-wide incident.
Consider the following branch WAN issue: An administrator loads a certificate with the wrong organizational root onto only one WAN Edge. What is the most relevant operational risk in this situation?
Trusting a different root cannot be repaired by changing overlay OMP route policy. Mutual SD-WAN control authentication requires compatible certificate authority trust roots. The recommended mitigation is: Replace the mismatched root CA chain with the fabric's configured trusted authority.
Deploying undersized controller VMs can cause unstable control sessions and management performance. That risk applies mainly to a different case: A company must operate its own SD-WAN Controllers in a private virtualization cluster.
Allowing controller certificates to expire can disconnect otherwise healthy Edge routers. That risk applies mainly to a different case: A control node's identity certificate will expire during a planned campus change freeze.
A valid signature alone may not authorize an unlisted device to join a controlled SD-WAN fabric. That risk applies mainly to a different case: A newly delivered Edge has a valid certificate but its serial number is absent from the fabric's authorized device inventory.
The team suggests this solution: Select supported controller virtual images and sufficient hypervisor compute, storage, and networking resources. The triggering scenario is: A company must operate its own SD-WAN Controllers in a private virtualization cluster. Which underlying SD-WAN behavior BEST explains the response?
On-premises controller deployment depends on supported virtual hosting and capacity planning. This technical mechanism explains why the recommended action works: Select supported controller virtual images and sufficient hypervisor compute, storage, and networking resources. A successful deployment should show: Manager, Validator, and Controllers boot on the approved hypervisor and present usable management services.
Controller installation requires reachable interfaces and matching fabric identity parameters. This principle is associated more closely with another situation: The first SD-WAN Controller VM starts but no control sessions form with WAN Edges on a remote network.
Secure control sessions require current signed device certificates that remain within their validity interval. This principle is associated more closely with another situation: A control node's identity certificate will expire during a planned campus change freeze.
The management-plane platform requires independent capacity planning from WAN Edge dataplane throughput. This principle is associated more closely with another situation: An on-premises Manager is underprovisioned and cannot retain telemetry for hundreds of routers.
Consider this Catalyst SD-WAN operating scenario: A site has working Controller connections, but an application tunnel stops passing packets when the circuit degrades. Which corrective response most directly meets the requirement?
Examine BFD tunnel sessions and measured loss, latency, and jitter on the affected TLOC pair. This is the targeted action for the stated case: A site has working Controller connections, but an application tunnel stops passing packets when the circuit degrades. The specific technical reason is: BFD monitors the liveliness and quality of the data-plane transport tunnels independently of OMP connectivity. Verification should demonstrate: BFD reports the actual data tunnel health and the unavailable path is no longer preferred for traffic.
Design the Cisco Catalyst SD-WAN Multi-Region Fabric with appropriate core and border-router placement. This would help with a different network situation: Two geographic regions must retain local routing while exchanging selected inter-region routes through a backbone.
Evaluate Cloud OnRamp for Colocation and its supported service-chain architecture. This would help with a different network situation: A branch needs a centralized security and service-chain location at a partner colocation facility before reaching external services.
Use the appropriate Multi-Region Fabric inter-region border controls and route policy design. This would help with a different network situation: The enterprise spans three regional fabrics, and an administrator wants to suppress needless routes outside their home region.
A Cisco SD-WAN deployment has completed the following step: Verify multicast receiver state and overlay distribution for the affected group after joins and leaves. The original case is: An overlay multicast deployment delivers traffic to the wrong sites when group membership changes. Which test result provides the strongest evidence that the change succeeded?
Sites without current group membership stop receiving the stream while active receivers continue. This observable result validates the corrective action: Verify multicast receiver state and overlay distribution for the affected group after joins and leaves.
The subscribed group and forwarding tree are visible and multicast packets reach authorized receivers. That observation would verify another change: Branch receivers issue IGMP joins but no multicast arrives from a campus source across the overlay. The expected result instead is: Sites without current group membership stop receiving the stream while active receivers continue.
Failing the primary link moves permitted traffic to the established alternate data-plane tunnel. That observation would verify another change: A link-redundant Edge should use a secondary internet TLOC when the primary data tunnel fails. The expected result instead is: Sites without current group membership stop receiving the stream while active receivers continue.
Only subscribed remote sites receive the intended multicast group after membership is established. That observation would verify another change: A video distribution service needs one multicast stream replicated efficiently to subscribed SD-WAN sites. The expected result instead is: Sites without current group membership stop receiving the stream while active receivers continue.
An engineer proposes this Catalyst SD-WAN remedy: Configure OSPF in the correct service VPN and export intended learned routes into OMP. The triggering scenario is: A branch Edge peers with a local OSPF router but its learned campus subnets do not enter the overlay. Which underlying SD-WAN behavior BEST explains the response?
Service-side OSPF exchanges LAN routes that can be redistributed into SD-WAN overlay routing. This technical mechanism explains why the recommended action works: Configure OSPF in the correct service VPN and export intended learned routes into OMP. A successful deployment should show: The OSPF neighbor is full and selected campus prefixes appear in remote OMP route tables.
SD-WAN policy and configuration objects require appropriate association and deployment to affect devices. This principle is associated more closely with another situation: A network team publishes a policy group but assumes the rule is active on every WAN Edge by default.
Device-specific template variables separate reusable configuration logic from per-router values. This principle is associated more closely with another situation: One device template is shared by 200 sites, but only the BGP neighbor address should differ per Edge.
BGP exchanges service-side routes with WAN Edge routing instances that integrate with OMP. This principle is associated more closely with another situation: A data-center Edge peers with existing BGP routers and must maintain route policies while joining the fabric.
Consider this Catalyst SD-WAN operating scenario: A critical financial application is identified by DPI but the AAR rule matches only TCP port 443 without app context. Which corrective response most directly meets the requirement?
Use the supported application-identification match in the AAR policy for the intended traffic class. This is the targeted action for the stated case: A critical financial application is identified by DPI but the AAR rule matches only TCP port 443 without app context. The specific technical reason is: Application-aware routing can use classified applications rather than only transport port numbers. Verification should demonstrate: Only the intended financial application receives the specified transport SLA behavior.
Add the correct VPN membership and route-advertisement permissions for that cloud site. This would help with a different network situation: A cloud branch is assigned to a new customer VPN but the Controller continues to distribute only the default service VPN.
Bind the SLA class to the intended AAR policy and activate it at the appropriate sites and VPNs. This would help with a different network situation: A network operator creates a new latency SLA but never associates it with any application traffic policy.
Use AI-driven predictive recommendations as supported decision input and validate policy and measured path results. This would help with a different network situation: An operator expects an AI-driven predictive path recommendation to guarantee that every future path failure is prevented.
A Cisco SD-WAN deployment has completed the following step: Evaluate supported Data Redundancy Elimination with appropriate peers and application eligibility. The original case is: A file-transfer workload repeatedly sends substantially identical large data blocks over a constrained WAN. Which test result provides the strongest evidence that the change succeeded?
Measured WAN bytes decrease for repeated data patterns without changing the recovered content. This observable result validates the corrective action: Evaluate supported Data Redundancy Elimination with appropriate peers and application eligibility.
The permitted collaboration app succeeds and the prohibited app generates matching firewall deny events. That observation would verify another change: A branch wants to allow collaboration applications but block an unauthorized remote-access application even on TCP 443. The expected result instead is: Measured WAN bytes decrease for repeated data patterns without changing the recovered content.
The specific application reaches its intended optimization service and returns correctly over the planned path. That observation would verify another change: A legacy application service must traverse an AppNav optimization function to improve WAN application experience. The expected result instead is: Measured WAN bytes decrease for repeated data patterns without changing the recovered content.
A controlled single-path loss produces fewer missed application packets when duplicate packets arrive. That observation would verify another change: A real-time application loses bursts of packets on one of two usable internet transports and can tolerate duplicate delivery. The expected result instead is: Measured WAN bytes decrease for repeated data patterns without changing the recovered content.
A network engineer is asked to resolve this SD-WAN issue: An administrator wants a branch's high-cost LTE link to remain present but act primarily as a backup TLOC. What is the most appropriate first configuration or operational step?
Advertise the backup transport and apply suitable path preferences or policy to favor the primary TLOC. This is the targeted action for the stated case: An administrator wants a branch's high-cost LTE link to remain present but act primarily as a backup TLOC. The specific technical reason is: TLOC availability and policy preference jointly determine which SD-WAN underlay transport is used. Verification should demonstrate: Ordinary traffic prefers primary transport while LTE remains available after a simulated primary outage.
Make the neighbor-address field device-specific in the appropriate Manager feature template or profile. This would help with a different network situation: One device template is shared by 200 sites, but only the BGP neighbor address should differ per Edge.
Align supported tunnel encapsulation settings on eligible transport endpoints. This would help with a different network situation: A transport route advertises a TLOC with an encapsulation type that does not match the intended peer tunnel design.
Restore a unique stable system IP and validate TLOC identities before changing transport policy. This would help with a different network situation: A branch changes its system IP during troubleshooting and unexpectedly affects many overlay transport advertisements.
or Guarantee your success by buying the full version which covers the full latest pool of questions. (480 Questions, Last Updated on Nov 11, 2026)
Please check your mailbox for a message from support@examlabs.com and follow the directions.