JN0-364 Premium File
- 69 Questions & Answers
- Last Update: Nov 4, 2026
Before changing configuration at Cascade Hosting, an engineer investigates: A neighbor's agreed selective-routing behavior fails because a community is added after the rejecting export term rather than before policy selection. Which first diagnostic most directly tests the suspected cause?
The check diagnoses a different layer of service. Its source issue is: Two eBGP routes have equal earlier BGP decision attributes and the operator needs to explain why a path with fewer AS numbers is preferred. The relevant initial check is: Inspect the prefix's community list before and after import/export policy and compare route term ordering.
This check may help with another root cause, for example: Two neighboring providers configured for eBGP have IP reachability but the BGP session remains Active because one side uses the wrong peer AS number. It does not test the first failed condition; start with: Inspect the prefix's community list before and after import/export policy and compare route term ordering.
That evidence could be normal while the reported defect persists. It is aimed at: An edge advertises unapproved internal prefixes after an operator broadens a BGP export term beyond the intended customer route set. Instead inspect: Inspect the prefix's community list before and after import/export policy and compare route term ordering.
Inspect the prefix's community list before and after import/export policy and compare route term ordering. BGP communities are route attributes used by policy rather than replacement next-hop addresses or MPLS labels.
At Northshore Utilities, a service provider router shows this failure: Two equal eligible BGP paths to a destination exist, but forwarding uses only the best path while the service design needs shared capacity. What is the best targeted configuration or operations action?
This action may apply to a different problem, for example: Two neighboring providers configured for eBGP have IP reachability but the BGP session remains Active because one side uses the wrong peer AS number. It does not repair the stated failure boundary. The case-specific reason is: Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths.
Enable supported BGP multipath for the intended group and verify the installed forwarding next-hop set under the required path-eligibility constraints. The case-specific reason is: Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths. A direct acceptance test is: The RIB and forwarding entry show multiple eligible next hops for the prefix and independent flows use more than one path as designed.
That would address a separate configuration fault: A BGP speaker learns a route from one iBGP peer but does not pass it to another internal peer, causing partial prefix visibility. This stem identifies a different cause, corrected by: Enable supported BGP multipath for the intended group and verify the installed forwarding next-hop set under the required path-eligibility constraints.
This action may apply to a different problem, for example: Two eBGP routes have equal earlier BGP decision attributes and the operator needs to explain why a path with fewer AS numbers is preferred. It does not repair the stated failure boundary. The case-specific reason is: Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths.
A change auditor at Northshore Utilities must validate remediation of this finding: Two equal eligible BGP paths to a destination exist, but forwarding uses only the best path while the service design needs shared capacity. Which test outcome is the strongest acceptance evidence?
The RIB and forwarding entry show multiple eligible next hops for the prefix and independent flows use more than one path as designed. Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths.
The observation confirms a different component's behavior. Its source context is: A service route remains hidden after an eBGP-to-iBGP handoff; the internal router knows the prefix but not a path to its advertised next hop. In this case the success criterion is: The RIB and forwarding entry show multiple eligible next hops for the prefix and independent flows use more than one path as designed.
That check proves something else, such as: A BGP speaker learns a route from one iBGP peer but does not pass it to another internal peer, causing partial prefix visibility. It could pass while the stated problem remains. The targeted evidence here is: The RIB and forwarding entry show multiple eligible next hops for the prefix and independent flows use more than one path as designed.
This would be valid for another situation: Two eBGP routes have equal earlier BGP decision attributes and the operator needs to explain why a path with fewer AS numbers is preferred. It does not establish that the failing boundary in this scenario works; verify: The RIB and forwarding entry show multiple eligible next hops for the prefix and independent flows use more than one path as designed.
The operations training team at Northshore Utilities discusses this issue: Two equal eligible BGP paths to a destination exist, but forwarding uses only the best path while the service design needs shared capacity. Which technical explanation matches the intended correction?
BGP multipath allows multiple sufficiently equal eligible BGP paths to contribute forwarding next hops, subject to routing-policy and hardware constraints. The key distinction is: Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths. Accordingly the remedy is: Enable supported BGP multipath for the intended group and verify the installed forwarding next-hop set under the required path-eligibility constraints.
The statement can be true when A provider changed a partner's ASN, leaving the old `peer-as` on its Junos BGP group while TCP connection attempts continue. But it does not explain the reported failure. Here: Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths.
The statement can be true when A carrier tags customer routes with a standard BGP community to drive downstream policy, but the tag never appears beyond the ingress edge. But it does not explain the reported failure. Here: Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths.
That principle belongs to a different service stage: An edge advertises unapproved internal prefixes after an operator broadens a BGP export term beyond the intended customer route set. The directly relevant mechanism is: BGP multipath allows multiple sufficiently equal eligible BGP paths to contribute forwarding next hops, subject to routing-policy and hardware constraints.
At Northshore Utilities, a service acceptance review considers the unresolved issue: Two equal eligible BGP paths to a destination exist, but forwarding uses only the best path while the service design needs shared capacity. Which operational exposure follows most directly?
That consequence is more closely associated with another deficiency, such as: A received iBGP route is visible in inet.0 but inactive because its BGP next hop cannot be resolved through the IGP. The described fault instead exposes: One carrier bears all traffic while redundant capacity sits idle despite an apparently dual-homed BGP topology.
One carrier bears all traffic while redundant capacity sits idle despite an apparently dual-homed BGP topology. The direct mitigation is: Enable supported BGP multipath for the intended group and verify the installed forwarding next-hop set under the required path-eligibility constraints.
The concern could occur elsewhere when A BGP speaker learns a route from one iBGP peer but does not pass it to another internal peer, causing partial prefix visibility. For the stated scenario, the immediate risk is: One carrier bears all traffic while redundant capacity sits idle despite an apparently dual-homed BGP topology.
That consequence is more closely associated with another deficiency, such as: A backbone operator needs to prefer a primary egress for all internal routers without changing the external partner's AS path length. The described fault instead exposes: One carrier bears all traffic while redundant capacity sits idle despite an apparently dual-homed BGP topology.
Before changing configuration at Northshore Utilities, an engineer investigates: Two equal eligible BGP paths to a destination exist, but forwarding uses only the best path while the service design needs shared capacity. Which first diagnostic most directly tests the suspected cause?
That evidence could be normal while the reported defect persists. It is aimed at: A provider receives a malformed or unauthorized customer prefix yet it enters route selection after a loose import policy. Instead inspect: Inspect best-path and alternate path attributes, multipath configuration and the forwarding next-hop group for the exact destination.
The check diagnoses a different layer of service. Its source issue is: Two eBGP routes have equal earlier BGP decision attributes and the operator needs to explain why a path with fewer AS numbers is preferred. The relevant initial check is: Inspect best-path and alternate path attributes, multipath configuration and the forwarding next-hop group for the exact destination.
Inspect best-path and alternate path attributes, multipath configuration and the forwarding next-hop group for the exact destination. Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths.
That evidence could be normal while the reported defect persists. It is aimed at: A service route remains hidden after an eBGP-to-iBGP handoff; the internal router knows the prefix but not a path to its advertised next hop. Instead inspect: Inspect best-path and alternate path attributes, multipath configuration and the forwarding next-hop group for the exact destination.
During a Junos network change at Brightwood Public Works, the engineer observes: A router has eBGP paths with equal relevant attributes and the operations team assumes both will automatically enter the forwarding table. Which remediation most directly fixes the described problem?
That would address a separate configuration fault: A provider changed a partner's ASN, leaving the old `peer-as` on its Junos BGP group while TCP connection attempts continue. This stem identifies a different cause, corrected by: Enable supported BGP multipath for the intended group and verify the installed forwarding next-hop set under the required path-eligibility constraints.
This action may apply to a different problem, for example: The provider expects a shorter AS path to win, but another path has a deliberately higher local preference and is selected instead. It does not repair the stated failure boundary. The case-specific reason is: Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths.
Enable supported BGP multipath for the intended group and verify the installed forwarding next-hop set under the required path-eligibility constraints. The case-specific reason is: Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths. A direct acceptance test is: The RIB and forwarding entry show multiple eligible next hops for the prefix and independent flows use more than one path as designed.
That would address a separate configuration fault: A team assumes periodic UPDATE messages keep a quiet BGP session alive, but the route table is stable and no updates are due. This stem identifies a different cause, corrected by: Enable supported BGP multipath for the intended group and verify the installed forwarding next-hop set under the required path-eligibility constraints.
The Junos team at Brightwood Public Works needs a success criterion for this defect: A router has eBGP paths with equal relevant attributes and the operations team assumes both will automatically enter the forwarding table. Which observed result most precisely confirms the intended repair?
That check proves something else, such as: A planned customer route appears in the partner's advertisements but Junos rejects it at an early inbound policy term. It could pass while the stated problem remains. The targeted evidence here is: The RIB and forwarding entry show multiple eligible next hops for the prefix and independent flows use more than one path as designed.
The RIB and forwarding entry show multiple eligible next hops for the prefix and independent flows use more than one path as designed. Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths.
The observation confirms a different component's behavior. Its source context is: An operator changes local preference on its own router expecting a remote AS to honor it, but the remote side never receives that attribute. In this case the success criterion is: The RIB and forwarding entry show multiple eligible next hops for the prefix and independent flows use more than one path as designed.
That check proves something else, such as: The provider expects a shorter AS path to win, but another path has a deliberately higher local preference and is selected instead. It could pass while the stated problem remains. The targeted evidence here is: The RIB and forwarding entry show multiple eligible next hops for the prefix and independent flows use more than one path as designed.
While analyzing a service failure at Brightwood Public Works, the following is observed: A router has eBGP paths with equal relevant attributes and the operations team assumes both will automatically enter the forwarding table. Which mechanism best explains the underlying control-plane or forwarding behavior?
The statement can be true when An edge advertises unapproved internal prefixes after an operator broadens a BGP export term beyond the intended customer route set. But it does not explain the reported failure. Here: Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths.
That principle belongs to a different service stage: A provider receives a malformed or unauthorized customer prefix yet it enters route selection after a loose import policy. The directly relevant mechanism is: BGP multipath allows multiple sufficiently equal eligible BGP paths to contribute forwarding next hops, subject to routing-policy and hardware constraints.
This explains a separate protocol behavior: An intermittent control-plane firewall blocks one BGP packet class, and operators need to separate OPEN, KEEPALIVE, UPDATE and NOTIFICATION behavior. In the current facts, the controlling mechanism is: BGP multipath allows multiple sufficiently equal eligible BGP paths to contribute forwarding next hops, subject to routing-policy and hardware constraints.
BGP multipath allows multiple sufficiently equal eligible BGP paths to contribute forwarding next hops, subject to routing-policy and hardware constraints. The key distinction is: Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths. Accordingly the remedy is: Enable supported BGP multipath for the intended group and verify the installed forwarding next-hop set under the required path-eligibility constraints.
The following provider defect remains uncorrected at Brightwood Public Works: A router has eBGP paths with equal relevant attributes and the operations team assumes both will automatically enter the forwarding table. What is the most direct service or security risk of leaving it unresolved?
The concern could occur elsewhere when A backbone operator needs to prefer a primary egress for all internal routers without changing the external partner's AS path length. For the stated scenario, the immediate risk is: One carrier bears all traffic while redundant capacity sits idle despite an apparently dual-homed BGP topology.
That consequence is more closely associated with another deficiency, such as: A team assumes periodic UPDATE messages keep a quiet BGP session alive, but the route table is stable and no updates are due. The described fault instead exposes: One carrier bears all traffic while redundant capacity sits idle despite an apparently dual-homed BGP topology.
It is a risk in another topology or protocol state: A planned customer route appears in the partner's advertisements but Junos rejects it at an early inbound policy term. Here the most direct failure path is: One carrier bears all traffic while redundant capacity sits idle despite an apparently dual-homed BGP topology.
One carrier bears all traffic while redundant capacity sits idle despite an apparently dual-homed BGP topology. The direct mitigation is: Enable supported BGP multipath for the intended group and verify the installed forwarding next-hop set under the required path-eligibility constraints.
A support escalation at Brightwood Public Works describes: A router has eBGP paths with equal relevant attributes and the operations team assumes both will automatically enter the forwarding table. Where should the Junos operator look first for decisive evidence?
This check may help with another root cause, for example: Two eBGP routes have equal earlier BGP decision attributes and the operator needs to explain why a path with fewer AS numbers is preferred. It does not test the first failed condition; start with: Inspect best-path and alternate path attributes, multipath configuration and the forwarding next-hop group for the exact destination.
That evidence could be normal while the reported defect persists. It is aimed at: Two paths learned inside one AS reach the same destination; the selected exit conflicts with policy despite the chosen link having fewer AS hops. Instead inspect: Inspect best-path and alternate path attributes, multipath configuration and the forwarding next-hop group for the exact destination.
Inspect best-path and alternate path attributes, multipath configuration and the forwarding next-hop group for the exact destination. Multiple BGP paths in route detail are not equivalent to active multipath forwarding across those paths.
This check may help with another root cause, for example: A provider advertises two links to a neighboring AS and wishes to express a preferred ingress while keeping the links as separate BGP paths. It does not test the first failed condition; start with: Inspect best-path and alternate path attributes, multipath configuration and the forwarding next-hop group for the exact destination.
Please check your mailbox for a message from support@examlabs.com and follow the directions.